If anyone wants to place the samples that were taken close to Zona Incognito, here is the info where I think they are close to and some notes on what to look at. Remember these are near surface samples, and you should be looking at the horizons in the photo,s.

1) the best photo of the sections to place these on would be your resitivity ones (the middle photo of each page) Look for the colors red/purple that fade to yellow as you go deeper.

2) look at your chargeability photos (the top ones) for mineralization at depth and how it may correspond with the surface samples. Look for the rust/red/purples that fade to yellow as you go up.

3) use you MT (the bottom photo) to determine structure in relation to the samples) Look for what appear to be bulbs/lines/ structures, clouds, etc. Look for the colors white/light blue and green and match these deep ones up with your chargeability photo,s (the top ones)

Anyhow, to have fun, here is the page #/here is where to look/ and what the grades are.

1)on pg 174 of the report, this is the cross section labled 1000N, look at the numbers going across the surface til you find 300-350, close to there,there was a sample taken of 47.5 g/t.

On that same page, find the surface # 1150-1250, there was a sample taken close to there of 12.42 g/t.

2) on pg 173, this is cross section line 750N, look for surface line 450-500, there was a sample of 50.46 g/t taken from there.

On the same page, surface line 1400, a historic sample was taken from there between 30-60g/t.

On the same page, surface line 2250, a sample of 12.87g/t was taken from there.

There are other lower grade samples taken in these areas, but I just gave you the highest ones so that it might be easier for you to make the connections.

I dont think I made any mistakes in plotting these, but maybe hog or bow can check my work, just in case.

DISCLAIMER

This is my understanding of how to GENERALLY interpret these slides. I am no tech nor geo and could be interpreting these wrong.