El Gallo Infill Drill Results & High Grade Mineralization Discovered
in response to
by
posted on
Aug 11, 2011 05:26PM
A high growth, low cost mid-tier silver and gold producer in the Americas
US Gold Corporation: El Gallo Infill Drill Results & High Grade Mineralization Discovered South of Resource | |||||
TORONTO, ONTARIO--(Marketwire - Aug. 11, 2011) - US GOLD CORPORATION (NYSE:UXG)(TSX:UXG) is pleased to announce assay results from several different areas at the El Gallo Project, located in Sinaloa State, Mexico, including: 1) infill drilling to the east, 2) an emerging high-grade zone to the southwest and 3) the Gold Zone. 1) El Gallo Infill Drill Results Recent drilling at El Gallo has been focused on the eastern limits of the deposit (Fig. 2). The objective was to increase the confidence associated with the inferred mineralization, which is expected to upgrade this portion of the resource to the measured and indicated categories and help establish a reserve for preparation of the ongoing feasibility study. Four holes, shown in the table below, were drilled inside the proposed pit design. Holes GAX-349 and GAX-351 successfully confirmed the presence of the inferred mineralization and help demonstrate the impressive grades and thicknesses associated with the Main Zone. Holes GAX-318 and GAX-333 were drilled with the objective of converting lower grade inferred mineralization. These holes encountered higher grades than anticipated. The original production study contemplated sending this mineralization to the heap leach pad, but with the increased grade, the mineralization would likely be processed at the mill, where higher silver recoveries and enhanced margins are expected. -------------------------------------------------------------- Silver Length From Silver Length From Hole # (gpt) (meters) (meters) (opt) (feet) (feet) ------------------------------------- ---------------------- GAX-349 180.4 72.4 0.0 5.3 237.5 0.0 Including 955.2 10.1 17.5 27.9 33.1 57.4 Including 2,382.1 2.6 23.4 69.5 8.5 76.8 ------------------------------------- ---------------------- ------------------------------------- ---------------------- GAX-351 168.1 36.6 0.0 4.9 120.1 0.0 Including 289.3 11.7 20.4 8.4 38.4 66.9 Including 735.0 0.8 24.4 21.4 2.6 80.1 And 88.7 27.4 44.5 2.6 89.9 146.0 Including 205.8 9.9 57.3 6.0 32.5 188.0 ------------------------------------- ---------------------- ------------------------------------- ---------------------- GAX-318 165.0 11.6 24.7 4.8 38.1 81.0 Including 443.0 2.0 32.4 12.9 6.6 106.3 And 79.2 7.4 85.5 2.3 24.3 280.5 ------------------------------------- ---------------------- ------------------------------------- ---------------------- GAX-333 89.8 26.7 4.6 2.6 87.6 15.1 Including 382.5 4.0 27.2 11.2 13.1 89.2 And 616.0 0.5 65.1 18.0 1.6 213.6 And 71.8 4.0 88.9 2.1 13.1 291.7 -------------------------------------------------------------- ------------------------------------------------------------- Silver Length From Silver Length From Hole # (gpt) (meters) (meters) (opt) (feet) (feet) ------------------------------------ ---------------------- GAX-317 210.4 3.4 57.2 6.1 11.2 187.7 Including 435.0 1.0 59.6 12.7 3.3 195.5 ------------------------------------ ---------------------- ------------------------------------ ---------------------- GAX-321 72.4 16.7 6.8 2.1 54.9 22.3 Including 351.0 1.0 8.2 10.2 3.3 26.9 Including 497.0 0.9 22.6 14.5 3.0 74.1 ------------------------------------ ---------------------- ------------------------------------ ---------------------- GAX-322 71.0 22.0 87.6 2.1 72.2 287.4 ------------------------------------ ---------------------- ------------------------------------ ---------------------- GAX-328 60.8 18.6 31.2 1.8 61.0 102.4 Including 656.0 0.5 49.3 19.1 1.6 161.7 ------------------------------------ ---------------------- ------------------------------------ ---------------------- GAX-338 65.3 20.8 86.8 1.9 68.2 284.8 Including 126.7 1.7 86.8 3.7 5.6 284.8 Including 122.5 3.0 98.5 3.6 9.8 323.2 ------------------------------------ ---------------------- ------------------------------------ ---------------------- GAX-335 162.7 5.2 47.4 4.7 17.1 155.5 Including 489.0 1.0 51.6 14.3 3.3 169.3 ------------------------------------------------------------- ------------------------------------------------------------- Silver Length From Silver Length From Hole # (gpt) (meters) (meters) (opt) (feet) (feet) ------------------------------------ ---------------------- GAX-329 93.3 12.2 110.6 2.7 40.0 362.9 Including 564.0 0.7 121.0 16.4 2.3 397.0 GAX-332 93.6 11.2 110.8 2.7 36.7 363.5 Including 421.0 1.2 115.3 12.3 3.9 378.3 ------------------------------------------------------------- On March 30th, US Gold announced that high-grade silver and gold mineralization had been intersected 400 m (1,300 ft) southwest of the resource. The initial hole retuned 2,400 gpt silver, 39.3 gpt gold over 0.6 m. Three additional holes have since been drilled. The first two holes, drilled to establish the orientation of the vein, intersected the zone but returned lower grades. The third hole, drilled to extend the mineralization to the east, returned additional high-grade as shown below (Fig. 2). Although more drilling is required, the results demonstrate the potential to develop a new high-grade zone at El Gallo. ---------------------------------------------------------------------------- Silver Gold Length From Silver Gold Length From Hole # (gpt) (gpt) (meters) (meters) (opt) (opt) (feet) (feet) -------------------------------------------- ----------------------------- GAXSW004 325.4 6.8 4.5 62.6 9.5 0.20 14.8 205.4 Including 675.0 13.9 1.5 62.6 19.7 0.41 4.9 205.4 Including 320.0 7.0 1.5 65.6 9.3 0.20 4.9 215.2 ---------------------------------------------------------------------------- The El Gallo Gold Zone is situated 200 m (655 ft) southeast of the resource (Fig. 2). The original interpretation was that the area was comprised of two mineral structures, with a near-surface gold-rich zone and a silver zone at depth. New drilling has intersected another gold occurrence below both of the previously known zones. The result is encouraging as it suggests there is potential for mineralization at depth, which has seen limited exploration. To date, ten holes have been completed in this area. ----------------------------------------------------------------- Gold Length From Gold Length From Hole # (gpt) (meters) (meters) (opt) (feet) (feet) ------------------------------------ -------------------------- GZX010 9.3 3.1 324.0 0.27 10.2 1,063.0 Including 22.5 1.1 326.0 0.66 3.6 1,069.6 ----------------------------------------------------------------- ABOUT US GOLD (www.usgold.com) US Gold's objective is to qualify for inclusion in the S&P 500 by 2015. US Gold explores for gold and silver in the Americas and is advancing its El Gallo Project in Mexico and its Gold Bar Project in Nevada towards production. US Gold's shares are listed on the NYSE and the TSX under the symbol UXG, trading 1.9 million shares daily during the past twelve months. US Gold's shares are included in S&P/TSX and Russell indices and Van Eck's Junior Gold Miners ETF. Rob McEwen, Chairman and CEO, owns 20% of the shares of US Gold. On June 14, 2011 the Company announced that Mr. McEwen proposed to combine the Company with Minera Andes to create a high growth, low-cost, mid-tier silver producer focused on the Americas. This news release has been viewed and approved by John Read, CPG, US Gold's consulting geologist, who is a Qualified Person as defined by National Instrument 43-101 and is responsible for program design and quality control of exploration undertaken by the Company at its Mexican exploration properties. Samples from the core drilling were split on-site at the Company's Magistral Mine property. One quarter to one half of the split drill core is shipped to ALS Chemex for sample preparation and analysis by 4-acid digestion with ICP determination for silver and fire assay for gold. Samples returning greater than 1500 ppm silver or 10 ppm gold were re-analyzed using gravimetric fire assay. Standards and blanks were inserted every 20 samples. All holes were drilled with HQ bits and reduced to NTW where required. Samples were taken based on lithologic and/or mineralized intervals and vary in length. The true width of the mineral zone has not been determined. Certain statements contained herein and subsequent oral statements made by and on behalf of the Company may contain "forward-looking statements" within the meaning of the Private Securities Litigation Reform Act of 1995. Such forward-looking statements may be identified by words such as "intends," "anticipates," "believes," "expects" and "hopes" and include, without limitation, statements regarding the Company's results of exploration, plan of business operations, potential contractual arrangements, receipt of working capital, anticipated revenues and related expenditures. Factors that could cause actual results to differ materially include, among others, those set forth in the Company's Annual Report on Form 10-K for the fiscal year ended December 31, 2010 and other filings with the Securities and Exchange Commission, under the caption "Risk Factors". Most of these factors are outside the control of the Company. Investors are cautioned not to put undue reliance on forward-looking statements. Except as otherwise required by applicable securities statutes or regulations, the Company disclaims any intent or obligation to update publicly these forward looking statements, whether as a result of new information, future events or otherwise. To view Table 1. Drill Results: Core Holes Assays, please visit the following link: http://media3.marketwire.com/docs/usgold_811_table_1.pdf To view Figure 1: El Gallo District - Location of Veins, please visit the following link: http://media3.marketwire.com/docs/usgold_811_fig_1.pdf To view Figure 2: El Gallo Mineralization: Plan (Aerial View), please visit the following link: http://media3.marketwire.com/docs/usgold_811_fig_2.pdf |
|