I understand when they got to the kimbie in the location of the sample the entire depth was removed over what they throught would be approximately 500 tones..... This was hauled out to the crusher site and stockpilled untill the crushing was done....

Hard to determine the exact amount you are pulling out untill after the job is done... 500 tones is not a very large area....so removing enough to ensure completion was done. Now if the whole lot gets sent in that would be nice..... fact is that additional kimbie will be much easier for additional samples...

The first 100T sample will likely stimulate decisions either for additional bulk samples, wait and see, or maybe a pre-emptive offer by other parties...... whomever they may be.

I would bet that the Canadian sample will be back sometime in mid Jan to month end.....Holding all my tickets till then, unless we see a shart run-up then I will likely swing trade a few as some others are doing. Too small a movement here to add additional presure on the stock...... but our day will come.

JMHO