Aiming to become the global leader in chip-scale photonic solutions by deploying Optical Interposer technology to enable the seamless integration of electronics and photonics for a broad range of vertical market applications

Free
Message: Re: Question to the forum ....you are implanting a bias in your question FJ
28
Nov 05, 2014 08:31PM
11
Nov 05, 2014 08:54PM
11
Nov 05, 2014 09:24PM
8
Nov 05, 2014 09:35PM
The process being followed in this case by asking for majority votes on the basis of ones opinion of misinformation is not democratic. It is fair to say that there are opinions that disagree with your findings FJ, and that, just because your post requesting more thumbs up gets a higher number than the other loaded question amounts to biasing the vote and should be sticken completely. We on this board trust that the hub leaders and fellow members capable of removing posts do so judisciously and reasonably. You may deny it FJ but you have a following that will support almost anything you post. That adds another layer of bias into the equation. The method employed in this case is therefor unjust imho and should not be followed in the future. Yes, keeping a handle on overly negative, maliscious or misinformation is paramount. That said there are differing opinions about whether what he posted was such and imo should not be put to a vote. There is not a reasonable mechanism in place on this board to facilitate adequately these disagreements of opinion. I have no problem with differing opinions and although some negativity can creep in there must be some middle ground to keeping this real and keeping it reasonable. I wish everyone well as we seek safe harbour. Sincerely. Derekwpg
13
Nov 06, 2014 01:26AM
1
Nov 06, 2014 01:36AM
10
Nov 06, 2014 03:17AM
1
Nov 06, 2014 03:18AM
3
Nov 06, 2014 05:15AM

Nov 06, 2014 07:25AM
23
Nov 06, 2014 09:02AM
2
Nov 06, 2014 09:12AM
16
Nov 06, 2014 09:18AM
3
Nov 06, 2014 09:30AM
11
Nov 06, 2014 09:33AM

Nov 06, 2014 09:36AM

Nov 06, 2014 09:39AM
3
Nov 06, 2014 09:51AM
20
Nov 06, 2014 09:51AM
6
Nov 06, 2014 09:54AM
3
Nov 06, 2014 09:59AM
3
Nov 06, 2014 10:00AM
1
Nov 06, 2014 11:02AM

Nov 06, 2014 11:29AM
Share
New Message
Please login to post a reply