HIGH-GRADE NI-CU-PT-PD-ZN-CR-AU-V-TI DISCOVERIES IN THE "RING OF FIRE"

NI 43-101 Update (September 2012): 11.1 Mt @ 1.68% Ni, 0.87% Cu, 0.89 gpt Pt and 3.09 gpt Pd and 0.18 gpt Au (Proven & Probable Reserves) / 8.9 Mt @ 1.10% Ni, 1.14% Cu, 1.16 gpt Pt and 3.49 gpt Pd and 0.30 gpt Au (Inferred Resource)

Free
Message: X Sections

X Sections - Rockaur & OldJoe

in response to by
posted on Oct 03, 2007 04:27AM

Rockaur: 

On your BEAUTIFUL graphic from Sept 27, I can't read the angle's.

Did you have the 45 and 70 degree angles from 7 & 8 available to you?

If not, can you adjust and repost:

--------------

Old Joe - Thank you for your great discussion, but I'm a visual guy and I'm having trouble without getting in straight in my head.

Thanks to you both.

BK

--------------------------

Here are Richard's quotes
From Sept 27 interview..

'Hole #7, drilled at a 45 degree angle, has intersepted the sulphide bearing zone for a total length of 73 meters."

'Hole #8, drille fro the save set up, at a 70 degree angle, is ongoing as we speak."

--------------------------


Here is the news release quote.
Hole NOT-07-07 has recently been completed. This hole is positioned at the same collar location as holes NOT-07-01 and 02 (a few meters away to allow for drill setup), however the azimuth was set at due east, to undercut Hole NOT-07-05 from the west. The initial dip of this hole was set at -45 degrees.

-----------------------

Here was my take (no doubt wrong)

 So, if hole #7 is a few meters from 1 and 2, and hole #8 is 'from the same set up' as 7, then I assume they are all starting in the same place and shooting out in different directions and angles like a fireworks explosion. This makes the best sense to me. easier to delineate what you know you have rather then hopping about punching holes hither and thither.

                                        ||||
                                   /  /  |   \    \
                                  /  /   |     \    \


--------------------------

Here is the data Rockaur posted....

 

 Hole #   easting   Northing    Azim    dip    Comments

1         12+25      5100       90     -45
 

2         12+25      5100       90     -65


3          ??         ??        ?       ? 100m NE of #1 #2
                                                undercut body

4          ??         ??        ?       ?       100m SW of #1 #2
                                                overcut body

5          ??         ??        n/a    -90      50m NE of #1 #2


6          ??         ??       270     ?        drilled towards #5 from east
                              (assume)

7         12+25      5100       45      ?        from # 1 towards #5 (due east)

 

------------------------

 

Share
New Message
Please login to post a reply